In cases where the machine requires a single price only, use the price configuration for Amit + VPOS listed above. In case of multiple machines, use the following option.

Includes six wires for pulse management.
The value is separated by a semi-colon list for the pulse length that you want to use
Configuration example:
- Decimal Place = 2, Currency = USD
- Pulse 1-6 active time in ms = 200; 200; 200; 200; 200; 200
- Pulse 1-6 inactive time in ms = 200; 200; 200; 200; 200; 200
- Credit per Pulse 1-6 = 25; 25; 25; 25; 25; 25
- Number of Pulses per Vend 1-6 = 8; 8; 8; 12; 12; 16
  - Displays 6 prices: 3*$2, 2*$3, and 1*$4
- Number of Pulses per Vend 1-6 = 8; 8; 8; 8
  - Displays 4 prices of $2

Pulse Identifier (1-6) - The pulse lines identifier seen in idle mode that identifies the machine in the room. The default values are 1 to 6.
Pulse Title (1-6):
- Text seen below the identifier that describes the pulse line.
- When the Pulse Title ID is defined, the screen switches every 3 seconds, showing the Price/ Title.
- Title examples:
  - Air and Vac
  - Washer and Dryer
  - Vanilla and Chocolate

Relay mode option:

Instead of sending pulses, the device can also work in relay mode, meaning that it can change the output level for activating any kind of motor. This behavior replaces the need for an external timer that transforms pulses to time for activating the motor.

To enable the relay mode, set the value to Time per Pulse 1 (sec) (Attribute 705) and then the device will activate the machine for time calculated by:

Time per Pulse 1 (sec) x Number of Pulses per Vend 1.

In such cases, the device will present the time count on the screen.

For example:

Number of pulses per vend = 4
Time per pulse (sec) = 10
The machine will be active for 40 seconds

There are 2 options in the relay mode:

Option to stop in the middle (no pay back on the time left)
No option to stop. The time will be completed without option to stop before the end.

Select the desired option by setting Pulse Options (Attribute 722) to 32.

Credit per vend option:

This is an option to set the credit per vend instead of credit per pulse, as an alternative to the formula of Price = Credit per Pulse * Number of Pulses. If you to set a price that can not be a result of this formula.

For example:

3 pulses per vend and price of 7.00. To achieve this, the user can set the credit per pulse to 700, the number of pulses per vend to 3, and set pulse options (Attribute 722) to “credit per vend”(=4). The credit per pulse will then become credit per vend.

Single Price per Pulse Line (Including configurations)

General

Single Price Configuration per Nayax Device

AMIT + VPOS

Touch Devices

Related articles