Count-Up Mode - Stop Count-Up & Power off

Stop Count-Up

To stop the count-up process and end the transaction before the maximum count-up is reached:

• Touch Devices - Use the X button on the Touch device.
• Amit & VPOS - Use the VPOS

To configure a stop button as an external button (i.e. instead of the built-in button), configure the attributes as follows:

• Devices Parameters group - Door Open Functionality attribute - Cancel.

To use the door open line as the button source, create a short circuit between the door open and GND wires to indicate a button press.

Count-up direction drop down > Stop when credit finish – the pulse will continue, even when the stop button is pressed, until the amount to be paid has been used in full: until delta time is finished and at least the minimum value is fulfilled.

If the power to the machine is turned off due to any reason while the device is in operation, the machine stops functioning and the Total Charge amount is saved in its memory. When the power is restored, the consumer is charged for the Total Charge.